adv7511: TX_EDID_PRESENT is still 1 after a disconnect
Commit Message
The V4L2_CID_TX_EDID_PRESENT control reports if an EDID is present.
The adv7511 however still reported the EDID present after disconnecting
the HDMI cable. Fix the logic regarding this control. This has been wrong
since the driver was added to the kernel.
Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Cc: <stable@vger.kernel.org> # for v3.12 and up
---
drivers/media/i2c/adv7511.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
@@ -1553,7 +1553,6 @@ static void adv7511_check_monitor_present_status(struct v4l2_subdev *sd)
/* update read only ctrls */
v4l2_ctrl_s_ctrl(state->hotplug_ctrl, adv7511_have_hotplug(sd) ? 0x1 : 0x0);
v4l2_ctrl_s_ctrl(state->rx_sense_ctrl, adv7511_have_rx_sense(sd) ? 0x1 : 0x0);
- v4l2_ctrl_s_ctrl(state->have_edid0_ctrl, state->edid.segments ? 0x1 : 0x0);
if ((status & MASK_ADV7511_HPD_DETECT) && ((status & MASK_ADV7511_MSEN_DETECT) || state->edid.segments)) {
v4l2_dbg(1, debug, sd, "%s: hotplug and (rx-sense or edid)\n", __func__);
@@ -1583,6 +1582,7 @@ static void adv7511_check_monitor_present_status(struct v4l2_subdev *sd)
}
adv7511_s_power(sd, false);
memset(&state->edid, 0, sizeof(struct adv7511_state_edid));
+ v4l2_ctrl_s_ctrl(state->have_edid0_ctrl, 0x0);
}
}
@@ -1685,6 +1685,7 @@ static bool adv7511_check_edid_status(struct v4l2_subdev *sd)
}
/* one more segment read ok */
state->edid.segments = segment + 1;
+ v4l2_ctrl_s_ctrl(state->have_edid0_ctrl, 0x1);
if (((state->edid.data[0x7e] >> 1) + 1) > state->edid.segments) {
/* Request next EDID segment */
v4l2_dbg(1, debug, sd, "%s: request segment %d\n", __func__, state->edid.segments);
@@ -1710,7 +1711,6 @@ static bool adv7511_check_edid_status(struct v4l2_subdev *sd)
ed.present = true;
ed.segment = 0;
state->edid_detect_counter++;
- v4l2_ctrl_s_ctrl(state->have_edid0_ctrl, state->edid.segments ? 0x1 : 0x0);
v4l2_subdev_notify(sd, ADV7511_EDID_DETECT, (void *)&ed);
return ed.present;
}