[v5,03/10] media: rkvdec: h264: Use bytesperline and buffer height as virstride
Commit Message
Use bytesperline and buffer height to calculate the strides configured.
This does not really change anything other than ensuring the
bytesperline that is signaled to userspace matches what is configured
in HW.
Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
Reviewed-by: Nicolas Dufresne <nicolas.dufresne@collabora.com>
Tested-by: Nicolas Dufresne <nicolas.dufresne@collabora.com>
Tested-by: Christopher Obbard <chris.obbard@collabora.com>
---
v5:
- Collect r-b and t-b tags
v4:
- No change
v3:
- Remove unnecessary yuv_virstride +=
drivers/staging/media/rkvdec/rkvdec-h264.c | 14 +++++++-------
1 file changed, 7 insertions(+), 7 deletions(-)
@@ -896,9 +896,9 @@ static void config_registers(struct rkvdec_ctx *ctx,
dma_addr_t rlc_addr;
dma_addr_t refer_addr;
u32 rlc_len;
- u32 hor_virstride = 0;
- u32 ver_virstride = 0;
- u32 y_virstride = 0;
+ u32 hor_virstride;
+ u32 ver_virstride;
+ u32 y_virstride;
u32 yuv_virstride = 0;
u32 offset;
dma_addr_t dst_addr;
@@ -909,16 +909,16 @@ static void config_registers(struct rkvdec_ctx *ctx,
f = &ctx->decoded_fmt;
dst_fmt = &f->fmt.pix_mp;
- hor_virstride = (sps->bit_depth_luma_minus8 + 8) * dst_fmt->width / 8;
- ver_virstride = round_up(dst_fmt->height, 16);
+ hor_virstride = dst_fmt->plane_fmt[0].bytesperline;
+ ver_virstride = dst_fmt->height;
y_virstride = hor_virstride * ver_virstride;
if (sps->chroma_format_idc == 0)
yuv_virstride = y_virstride;
else if (sps->chroma_format_idc == 1)
- yuv_virstride += y_virstride + y_virstride / 2;
+ yuv_virstride = y_virstride + y_virstride / 2;
else if (sps->chroma_format_idc == 2)
- yuv_virstride += 2 * y_virstride;
+ yuv_virstride = 2 * y_virstride;
reg = RKVDEC_Y_HOR_VIRSTRIDE(hor_virstride / 16) |
RKVDEC_UV_HOR_VIRSTRIDE(hor_virstride / 16) |