[v3,13/19] media: ti-vpe: cal: fix dummy read to phy
Commit Message
After ComplexIO reset, a dummy read to PHY is needed as per CAL spec to
finish the reset. Currently the driver reads a ComplexIO register, not
PHY register. Fix this.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Tested-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Reviewed-by: Benoit Parrot <bparrot@ti.com>
---
drivers/media/platform/ti-vpe/cal.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
@@ -796,8 +796,8 @@ static void csi2_phy_init(struct cal_ctx *ctx)
ctx->csi2_port,
reg_read(ctx->dev, CAL_CSI2_COMPLEXIO_CFG(ctx->csi2_port)));
- /* Dummy read to allow SCP to complete */
- val = reg_read(ctx->dev, CAL_CSI2_COMPLEXIO_CFG(ctx->csi2_port));
+ /* Dummy read to allow SCP reset to complete */
+ reg_read(ctx->cc, CAL_CSI2_PHY_REG0);
/* 3.A. Program Phy Timing Parameters */
csi2_phy_config(ctx);