[2/3,media] tvp5150: Add video format registers configuration values
Commit Message
The tvp5150 video decoder has two operation modes to configure the video
standard used.
If auto-switch mode is enable, the device can sense the signal and detect which
video standard the device is operating. Also the device can be forced to use a
user defined video standard.
Each operation mode uses a different register and the bitmask values to
represent each standard is different.
So we add video standard constants for both autoswitch and no-autoswitch mode.
Signed-off-by: Javier Martinez Canillas <martinez.javier@gmail.com>
---
drivers/media/video/tvp5150_reg.h | 17 ++++++++++++++++-
1 files changed, 16 insertions(+), 1 deletions(-)
@@ -45,7 +45,22 @@
/* Reserved 1Fh-27h */
-#define TVP5150_VIDEO_STD 0x28 /* Video standard */
+#define VIDEO_STD_MASK (0x07 >> 1)
+#define TVP5150_VIDEO_STD 0x28 /* Video standard */
+#define VIDEO_STD_AUTO_SWITCH_BIT 0x00
+#define VIDEO_STD_NTSC_MJ_BIT 0x02
+#define VIDEO_STD_PAL_BDGHIN_BIT 0x04
+#define VIDEO_STD_PAL_M_BIT 0x06
+#define VIDEO_STD_PAL_COMBINATION_N_BIT 0x08
+#define VIDEO_STD_NTSC_4_43_BIT 0x0a
+#define VIDEO_STD_SECAM_BIT 0x0c
+
+#define VIDEO_STD_NTSC_MJ_BIT_AS 0x01
+#define VIDEO_STD_PAL_BDGHIN_BIT_AS 0x03
+#define VIDEO_STD_PAL_M_BIT_AS 0x05
+#define VIDEO_STD_PAL_COMBINATION_N_BIT_AS 0x07
+#define VIDEO_STD_NTSC_4_43_BIT_AS 0x09
+#define VIDEO_STD_SECAM_BIT_AS 0x0b
/* Reserved 29h-2bh */