[1/2] media: dt-bindings: media: i2c: Switch to assigned-clock-rates
Commit Message
Use assigned-clock-rates to specify the clock rate.
Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@bp.renesas.com>
---
Documentation/devicetree/bindings/media/i2c/ov5645.txt | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
@@ -8,7 +8,6 @@ Required Properties:
- compatible: Value should be "ovti,ov5645".
- clocks: Reference to the xclk clock.
- clock-names: Should be "xclk".
-- clock-frequency: Frequency of the xclk clock.
- enable-gpios: Chip enable GPIO. Polarity is GPIO_ACTIVE_HIGH. This corresponds
to the hardware pin PWDNB which is physically active low.
- reset-gpios: Chip reset GPIO. Polarity is GPIO_ACTIVE_LOW. This corresponds to
@@ -37,7 +36,8 @@ Example:
clocks = <&clks 200>;
clock-names = "xclk";
- clock-frequency = <24000000>;
+ assigned-clocks = <&clks 200>;
+ assigned-clock-rates = <24000000>;
vdddo-supply = <&camera_dovdd_1v8>;
vdda-supply = <&camera_avdd_2v8>;