[v5,06/14] media: ov772x: use generic names for reset and powerdown gpios
Commit Message
The ov772x driver uses "rstb-gpios" and "pwdn-gpios" for reset and
powerdown pins. However, using generic names for these gpios is
preferred. ("reset-gpios" and "powerdown-gpios" respectively)
There is only one mainline user for these gpios, so rename to generic
names.
Cc: Jacopo Mondi <jacopo+renesas@jmondi.org>
Cc: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Cc: Hans Verkuil <hans.verkuil@cisco.com>
Cc: Sakari Ailus <sakari.ailus@linux.intel.com>
Cc: Mauro Carvalho Chehab <mchehab@s-opensource.com>
Reviewed-by: Jacopo Mondi <jacopo@jmondi.org>
Signed-off-by: Akinobu Mita <akinobu.mita@gmail.com>
---
* v5
- No changes
arch/sh/boards/mach-migor/setup.c | 5 +++--
drivers/media/i2c/ov772x.c | 8 ++++----
2 files changed, 7 insertions(+), 6 deletions(-)
@@ -351,8 +351,9 @@ static struct platform_device migor_ceu_device = {
static struct gpiod_lookup_table ov7725_gpios = {
.dev_id = "0-0021",
.table = {
- GPIO_LOOKUP("sh7722_pfc", GPIO_PTT0, "pwdn", GPIO_ACTIVE_HIGH),
- GPIO_LOOKUP("sh7722_pfc", GPIO_PTT3, "rstb", GPIO_ACTIVE_LOW),
+ GPIO_LOOKUP("sh7722_pfc", GPIO_PTT0, "powerdown",
+ GPIO_ACTIVE_HIGH),
+ GPIO_LOOKUP("sh7722_pfc", GPIO_PTT3, "reset", GPIO_ACTIVE_LOW),
},
};
@@ -837,10 +837,10 @@ static int ov772x_power_on(struct ov772x_priv *priv)
* available to handle this cleanly, request the GPIO temporarily
* to avoid conflicts.
*/
- priv->rstb_gpio = gpiod_get_optional(&client->dev, "rstb",
+ priv->rstb_gpio = gpiod_get_optional(&client->dev, "reset",
GPIOD_OUT_LOW);
if (IS_ERR(priv->rstb_gpio)) {
- dev_info(&client->dev, "Unable to get GPIO \"rstb\"");
+ dev_info(&client->dev, "Unable to get GPIO \"reset\"");
return PTR_ERR(priv->rstb_gpio);
}
@@ -1307,10 +1307,10 @@ static int ov772x_probe(struct i2c_client *client,
goto error_ctrl_free;
}
- priv->pwdn_gpio = gpiod_get_optional(&client->dev, "pwdn",
+ priv->pwdn_gpio = gpiod_get_optional(&client->dev, "powerdown",
GPIOD_OUT_LOW);
if (IS_ERR(priv->pwdn_gpio)) {
- dev_info(&client->dev, "Unable to get GPIO \"pwdn\"");
+ dev_info(&client->dev, "Unable to get GPIO \"powerdown\"");
ret = PTR_ERR(priv->pwdn_gpio);
goto error_clk_put;
}